ESP32 CONNECTED · LIVE
SYSTEM READY

Battery Intelligence

Real-time SOH estimation and impedance analysis.

SOH Estimate94%
Calibrated: 12h agoHealthy
Cell Voltage
3.72VStable output
Current Load
1.2APRBS active
Temperature
24°CWithin limits
LIVE ANALYSISEIS-LITE COCKPIT

Battery Intelligence

Real-time electrochemical impedance spectroscopy and SOH estimation powered by ESP32 PRBS signal processing.

SYNC: 14:22:05 UTC
SYS-SOH-01HEALTHY
State of Health
Battery Integrity
94.2%
Target: 100.0 %-0.2%
Confidence94.2%

Cycle Count

412

Capacity

48.2 Ah

SYS-VOLT-02STABLE
Cell Voltage
Terminal Potential
3.72V
Target: 4.20 V+0.01
Confidence88.5%

Min Voltage

3.68 V

Max Voltage

3.75 V

SYS-OHM-03NOMINAL
Ohmic Rs
Internal Resistance
12.4mΩ
Target: 10.0 mΩ+0.2
Confidence80.6%

Contact Res

0.8 mΩ

Electrolyte

Stable

SYS-RCT-04OPTIMAL
Charge Transfer
Rct Resistance
42.8mΩ
Target: 50.0 mΩ-1.2
Confidence85.6%

Double Layer

1.2 F

Warburg

0.04 Ω

Current Load

1.24 A

Discharge Rate

Temperature

24.8 °C

Ambient Sensor

Test Status

Running

PRBS Sequence

Connection

ESP32-AP

Wi-Fi Link Active

Calibration Status: Validated

SOH estimator calibrated against reference impedance measurements.

Live Acquisition Node•SESSION ID: #EIS-2025-04A

Active Session Monitor

Synchronized multi-frequency PRBS excitation and potentiostatic state estimator running on ESP32.

ESP32 AP: ConnectedPRBS Active (10 Hz – 1 kHz)
State of Health
90.2%
Randles Fit
Cell Voltage
3.835
V DC
PRBS Current
121.4
mA RMS
Ohmic Rs
16.9
mΩ
Transfer Rct
38.4
mΩ
Elapsed Sweep
42s
Frame 04/10
SOH Degradation Profile
Historical cycle capacity retention versus charge-transfer resistance (Rct)
Calibrated Randles EstimateDelta Rs: +2.8 mΩ total
Synchronized ADC Waveform
Real-time cell terminal voltage & dual-channel PRBS excitation stream
Streaming
Sampling: 10 kSps / 12-bit ADCTemp: 24.6°C
Test History
ESP32 LINKED

Recent Test Summary

Review historical battery impedance measurements, SOH estimates, and diagnostic flags from the ESP32 local storage.

Total Tests
142
Stored in local browser cache
Avg SOH
92.4%
Based on 84 calibrated tests
Avg Rs (Ω)STABLE
0.048
Ohmic resistance mean
Error Rate2.1%
3
Failed measurement sessions
Test IDBatteryRs (Ω)Rct (Ω)SOH (%)StatusActions
T-9042BATT-0010.0420.11594.2DONE
T-8193BATT-0020.0550.180–ERROR
T-7721BATT-0010.0410.11294.5DONE
T-6634BATT-0030.0380.09598.1IDLE
T-5519BATT-0040.0000.000–ERROR
T-4482BATT-0020.0520.17588.4DONE
EIS-Lite Data Protocol v1.0 • Local Storage Active
System Ready

Measurement Control

Manage your battery test sessions directly from the ESP32 interface. Start, monitor, or abort measurements with precision.

Idle
Test Execution
Initiate PRBS excitation or stop current measurement cycles safely.
  • PRBS sequence active
  • Real-time impedance sync
  • Hardware safety interlock
Connected
Device Status
Monitor ESP32 telemetry, connection quality, and system health.
  • ESP32 connection stable
  • Sampling frequency: 1kHz
  • Thermal limit monitoring